Eliminating Your Old Warm Water Heaters
Start heater treatment by switching from the electricity or gas to your heater. Empty the heater. Starting a warm water faucet will allow air to the system. On a gasoline heater, divide the vent pipeline through the draft bonnet. It must raise down after getting rid of the sheet steel screw that holds it. After making sure the pilot light has gone out, disconnect the gas line during the cap and heater it. Next, take away the heater from the water piping. If related to unions–removable threaded fittings–take them apart with a set of pipe wrenches. Pipelines without unions must be hacksawed down. Or a pipe/tubing cutter will perform the job. The old heater can now be used away and discarded at a dumpsite.
Setting up the Brand New Heater
Simply take your new heater to its location by “walking” it or making use of an appliance cart, dolly, or hand vehicle. Position the brand new heater so your piping–particularly a gasoline vent pipe–will reach many effortlessly. Install the heater’s brand brand new draft bonnet (fuel heater). Numerous have actually feet that insert into holes regarding the heater’s top.
Every fuel hot water heater requires appropriate venting that’s no smaller compared to the draft bonnet collar associated with the brand new heater. It is a good notion to utilize brand new vent pipe elbows, while the old people will likely be corroded at their current perspectives. The vent should up go straight in terms of feasible. Then any run that is horizontal slope upward at the very least 1/4 inches per base. Link the vent pipeline with quick sheet steel screws.
You will result in the hot and water that is cold. Continue lendo